Configuration of IP Telephony nodes using OTM 2.2 Page 455 of 910
IP Line Description, Installation and Maintenance
Node definition
A node is defined as a collection of Signaling Servers and Voice Gateway
Media Cards (ITG-P 24-port line cards and Media Card 8-port and 32-port
line cards). Each node in the network has a unique Node ID. This Node ID is
an integer value. A node has only one primary or Leader Voice Gateway
Media Card. All the other Voice Gateway Media Cards are defined as
Followers.
Note 1: All IP addresses and subnet mask data must be in dotted decimal
format. Convert subnet mask data from Classless Inter-Domain (CIDR)
format.
Note 2: Refer to Table 57 on page 307 for IP addresses and information
required in this procedure.
WARNING
OTM 2.2 does not support configuration of nodes which
reside on a CS 1000 system. However, since OTM 2.2 is
required for retrieval of Operational Measurement (OM)
reports from nodes on these systems, OTM is capable of
being configured with basic network connection
information of the node. The necessary configuration to
retrieve the OM reports is covered in Procedure 49 on
page 456 through Procedure 53 on page 472. In these
procedures, pay special attention to any comments
specific to nodes which reside on a CS 1000 system.