Page 306 of 910 Installation and configuration summary
553-3001-365 Standard 4.00 August 2005
9Configure OTM alarm notification feature to receive IP Line SNMP traps.
See Procedure 68 on page 523.
10 Assemble and install an IP Phone. Refer to IP Phones: Description,
Installation, and Operation (553-3001-368).
11 Change the default IP Line CLI (IPL>) Shell password. See Procedure 69
on page 553.
12 Configure the IP Phone Installer Passwords (see page 543).
a. Enable and set the administrative IP Phone Installer Password. See
Procedure 69 on page 553.
b. If needed, enable and set a temporary IP Phone Installer Password.
See Procedure 70 on page 556.

Voice Gateway Media Card installation summary sheet

Nortel recommends that a Voice Gateway Media Card installation summary
sheet (see Table 57 on page 307) be filled out as the line cards are unpacked,
inventoried, and provisioned. IP address information is usually supplied by
the IP Network Administrator.
To complete the installation summary sheet, the following information is
required:
• MAC address. This is the ELAN network interface MAC address on the
Voice Gateway Media Card faceplate sticker (for example,
00:60:38:01:12:77).
• ELAN network interface IP address, used to perform management
through OTM and to communicate with the system
• TLAN Node IP address for the IP Telephony node
• TLAN network interface IP address on each card
• IP address of the active ELNK Ethernet network interface on the system
core
Nortel recommends that an IP Phone configuration data summary sheet (see
Table 58 on page 308) be filled out as the IP Phones are installed and
configured.