Page 178 of 910 Features
553-3001-365 Standard 4.00 August 2005
Notice how the “Found on” line is below the title, and is displayed before
every IP Phone.
Note: If a PVQM command is entered with an IP address that multiple
IP Phones are using, then an error message is also printed.
WARNING: There are 2 IP Phones that use the public IP
address of 47.11.217.102
These PVQM commands include:
•RTPStatShow
• RTPTraceShow
• RTPTraceStop
•rPing
•rPingStop
• rTraceRoute
• rTraceRouteStop
• eStatShow
• RUDPStatShow
• isetInfoShow
echoServerShow
The echoServerShow command provides both configuration information
about the Echo Servers and information about interactions with the Echo
Servers for the IP Phones on a specific LTPS. Use this command on an LTPS
card to investigate a problem with an IP Phone registered to that LTPS card.
This is a per-card command that provides information on the Echo Servers
from the viewpoint of the LTPS on the card where the command is entered.
The command has one optional parameter, “action”; the only valid value is
99. When echoServerShow 99 is entered, the counter values are reset after
they are displayed. When just echoServerShow is entered, the counter
values are displayed without being reset.