Voice Gateway Media Card maintenance using OTM 2.2 Page 801 of 910
IP Line Description, Installation and Maintenance

Replace a Leader Voice Gateway Media Card

To replace a Leader Voice Gateway Media Card, follow the steps in

Procedure 112.

Procedure 112
Replacing a Leader Voice Gateway Media Card
1Locate the faulty card in the OTM IP Telephony database by the TN, MAC
address, and IP address.
2Disable the faulty Voice Gateway Media Card in LD 32 with the DISI
command. The system displays “NPR0011” when the card has been
completely disabled by the DISI command.
3Use the disiTPS command at the IPL> CLI to disable the LTPS on the
faulty Voice Gateway Media Card.
Note: This forces all Internet Telephones registered on this card to
reregister. If there are sufficient resources, this can take up to several
minutes. If there are not sufficient resources, Internet Telephones can
remain unregistered indefinitely.
4Use the isetShow command to monitor the status of the card and the
reregistration of the IP Phone. The Voice Gateway Media Card is
completely disabled when no IP Phones are registered on the card.
5Remove the faulty Voice Gateway Media Card from the system.
6Install the replacement Voice Gateway Media Card into the card slots in
the Meridian 1/ CS 1000M IPE module, Option 11C/CS 1000M Cabinet,
CS 1000E Media Gateway 1000E/Media Gateway 1000E Expander,
CS 1000S Media Gateway 1000S/Media Gateway 1000S Expander. To
do this:
a. Pull the top and bottom locking devices away from the card faceplate.
b. Insert the Voice Gateway Media Card into the card guides and gently
push it until it makes contact with the backplane connector. Hook the
locking devices.

CAUTION

This procedure is not supported for a node that resides
on a CS 1000 system.