Configuration of IP Telephony nodes using OTM 2.2 Page 529 of 910
IP Line Description, Installation and Maintenance
Device Name – the device name can be any string. Nortel recommends
that abbreviations for the site and system, the card functions, and the
Terminal Numbers (TNs) are used, such as
Site_System_Leader/Follower_TN. Note: Spaces should not be used in
the Device Name. Use an underscore (_) as a separator.
The Leader card has two IP addresses: the card voice IP address (TLAN)
and the node IP address. The Follower cards have only a single IP
address, the TLAN IP address.
End of Procedure

Assemble and install an IP Phone

To assemble and install an IP Phone, refer to IP Phones: Description,
Installation, and Operation (553-3001-368).

Change the default IPL> CLI Shell password

The IPL> CLI is password-protected for Telnet access and access to the local
maintenance port. The same user name and password also protects FTP
access to the Voice Gateway Media Card. The IPL> CLI has a default user
name of itgadmin and a default password of itgadmin.
Refer to “IPL> CLI Shell user name and password” on page 539 and “Node
password synchronization” on page 541 for more detailed information on the
passwords.

Configure the IP Phone Installer Passwords

The IP Phone Installer Password protection, required for changing the TN on
the IP Phone, controls registration with a virtual line TN on the Call Server.
See page 543 for more information about the IP Phone Install Passwords.
To enable and set the administrative IP Phone Installer Password, see
Procedure 69 on page 553. If needed, enable and configure a temporary
IP Phone Installer Password. See Procedure 70 on page 556.