Page 310 of 910 Installation and initial configuration of an IP Telephony node
553-3001-365 Standard 4.00 August 2005
Configure IP Phone features in LD 11. . . . . . . . . . . . . . . . . . . . . . . 351
Configure the IP Phone KEM . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 353
IP Phone dedicated soft keys . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 358
Node election rules . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 359
Introduction
This chapter explains how to install and perform the initial configuration of
new IP Telephony nodes, Voice Gateway Media Cards (ITG-P 24-port and
Media Card line cards), and associated cables.
Before installing an IP Telephony node, refer to Converging the Data
Network with VoIP (553-3001-160) for information on IP network
engineering guidelines.
Meridian 1
If configuring IP Line 4.5 on a Meridian 1, complete the remainder of the
configuration of IP Line data using Optivity Telephony Manager (OTM) 2.2.
CS 1000
If configuring IP Line 4.5 on a CS 1000 system, complete the remainder of
the configuration of IP Line data using Element Manager.

Installation and configuration procedures

The following is a list of procedures in this chapter:
• “Installing the ITG-P 24-port line card” on page 316
• “Installing the CompactFlash card on the Media Card” on page 318
IMPORTANT!
The maximum number of Voice Gateway Media Cards that can be
installed in each node is 30. When more than 30 Voice Gateway Media
Cards are needed on a single CS 1000 system, then multiple nodes
must be used. The maximum number of Signaling Servers and Voice
Gateway Media Cards that can be combined within a node is 35.