IP Line administration using OTM 2.2 Page 667 of 910
IP Line Description, Installation and Maintenance
Changes can be made to the SNMP Traps and Card routing table entries
without affecting other IP addresses. Change the SNMP traps and Card
routing table entries as required, based on the trap destination to be
reached.
IP addresses that are added in this tab create special card routing tables
that direct packets out the ELAN network interface and ELAN gateway.
Exercise caution when adding entries as the entry could result in one-way
voice transmission, if a change results in voice packets being streamed
out the ELAN network interface instead of the TLAN network interface.
Under SNMP Traps, up to eight SNMP trap destinations can be defined.
Under Card routing table entries, use caution when assigning card
routing table entries. Do not include the IP address of an IP Phone.
Otherwise, voice traffic to these IP Phones is incorrectly routed through
the ELAN and ELAN gateway. To avoid including the wrong IP address,
Nortel recommends that Host IDs be defined for the card routing table
entries.
12 Click Apply if any changes are made on the SNMP Traps/Routing and
IPs tab.
13 Select the Ports tab. See Figure 227 on page 668.