Configuration of IP Telephony nodes using Element Manager Page 411 of 910
IP Line Description, Installation and Maintenance

Configure the Follower cards

To configure a Follower card, follow the steps in Procedure 38.

Procedure 38
Configuring the Follower cards
1Check the displays on the card faceplate.
• After successfully rebooting, the Leader card is now fully configured
with the node properties of the node. The card enters a state of
“active Leader”. The card faceplate display shows Lxxx, where
xxx = the number of IP Phones registered with the LTPS on the
Leader card.
L000 shows that no IP Phones are registered.
• The Follower cards receive their BOOTP configuration information
from the Leader card. The Follower card faceplate display shows
Fxxx, where xxx = the number of IP Phones registered with the
Follower card’s LTPS.
F000 shows that no IP Phones are registered.
2Reboot the Follower card if the card’s faceplate does not display FXXX or
F000.
3Once all the Follower cards have the correct display on their faceplates,
log into Element Manager.
4Select IP Telephony > Nodes: Servers, Media Cards > Configuration.
The Node Configuration window opens.
5Click the Transfer/Status button associated with the node.
The Transfer/Status window opens. See Figure 108 on page 412.