Page 616 of 910 IP Line administration using Element Manager
553-3001-365 Standard 4.00 August 2005

Restart a Voice Gateway Media Card

If the IP address of a single Voice Gateway Media Card has changed, it must
be restarted in order for the changes to take effect.
Note: If IP addresses that affect the entire node are changed, all cards in
the node must be restarted. See “Restart all the Voice Gateway Media
Cards” on page 619.
Changes to the SNMP trap destination IP addresses take place immediately
when the transfer occurs; restarting the cards is not required.
If the IP address of a Voice Gateway Media Card has changed, restart only
that card.
Follow the steps in Procedure 81 to restart a specific card using the CLI.
Alternatively, a Voice Gateway Media Card can be restarted from within
Element Manager. Follow the steps in Procedure 82 to restart the card using
Element Manager.
Procedure 81
Restarting a Voice Gateway Media Card at the CLI
1To prevent interruption to the speech path, log into LD 32.
2Type the DISI command.
This command disables the voice gateway channels when they become
idle. DISI removes the call traffic but does not remove the IP Phones that
are registered on that Voice Gateway Media Card. The Graceful TPS
Disable command disiTPS removes the registered IP Phones.
3Type disiTPS at the card’s IPL> prompt to disable the LTPS service on
the Voice Gateway Media Card.
This Graceful TPS Disable command prevents new IP Phones from
registering on the card. All IP Phones registered on the card are
re-directed to another Voice Gateway Media Card when the IP Phone
becomes idle.