Page 766 of 910 Voice Gateway Media Card maintenance
553-3001-365 Standard 4.00 August 2005

Upgrade the Media Card firmware

There are two different hardware platforms for the Media Card. Firmware
release 8.x is for the NTVQ01AB/BB Media Card platform Media card
32-port card). Firmware release 6.x is for the NTVQ01AA/BA Media Card
platform (Media Card 8-port card). The firmware releases cannot be used
interchangeably between the two types of cards. However, the upgrade
procedure remains the same for both hardware platforms.
Note: If the Media Card is NTVQ01AA Release 8 vintage or earlier,
firmware cannot be upgraded unless the 8051 OTP part is changed on the
board. NTVQ01AA cards Release 9 and later can be upgraded as
described in this section. The release label is on the faceplate below the
Hex display.
Follow the steps in Procedure 106 to upgrade the Media Card firmware.
Procedure 106
Upgrading the Media Card firmware
1Determine if the firmware upgrade is required and if the card can have its
firmware upgraded by this process.
IPL> firmwareVersionShow
Firmware Version = ITG Firmware Rls 6.5
value = 40 = 0x28 = '('
IPL>
2Check the release label on the faceplate (below the Hex display) and
ensure it is newer than NTVQ01AA Release 8.
3Reboot the card.
4While the card is booting, break into the BIOS by entering jkl when
prompted.
5At the prompt enter the following commands:
-> initMm
value = 0 = 0x0
-> spawnMm
value = 0 = 0x0
6Depending on the location of the software file, enter one of the following
commands as shown in Table 108.