Page 776 of 910 Voice Gateway Media Card maintenance using Element Manager
553-3001-365 Standard 4.00 August 2005
6Install the replacement Voice Gateway Media Card into the card slot in the
system. To do this:
a. Pull the top and bottom locking devices away from the card faceplate.
b. Insert the Voice Gateway Media Card into the card guides and gently
push the card until it makes contact with the backplane connector.
Hook the locking devices.
Note 1: When cards are installed, the red LED on the faceplate remains
lit until the card is configured and enabled in the software, at which point
in turns off. If the LED does not follow the pattern described or operates
in any other manner (such as continually flashing or remaining weakly lit),
replace the card.
Note 2: Observe the faceplate maintenance display to see start-up
self-test results and status messages. A display of the type F:xx indicates
a failure. Refer to Table 79 on page 689 for a listing of the ITG-P 24-port
line card’s display codes and to Table 80 on page 691 for a listing of the
Media Card’s display codes.
7Go to the VxWorks shell. Configure the Voice Gateway Media Card as a
Leader using the ELAN network interface IP address and subnet mask.
8Restart the card.
The card obtains the ELAN network interface IP address and subnet
mask.
9In the Element Manager navigator, click IP Telephony > Nodes:
Servers, Media Cards > Configuration.
The Node Configuration window opens.
10 Click the Edit button associated with the node containing the card to be
replaced.
The Edit window opens.
11 Expand the Cards section by clicking the plus sign (+) to the left of Cards.
12 Select the Voice Gateway Media Card from the list of cards in the node.
See Figure 239 on page 774.