Page 726 of 910 Voice Gateway Media Card maintenance
553-3001-365 Standard 4.00 August 2005

Voice Gateway commands

Table 95 lists the Voice Gateway commands used on the Voice Gateway
Media Card.
vgwShow
The vgwShow command can be issued with no parameters or with the IP
address of an IP Phone using one of the Voice Channels.
vgwShow “x.x.x.x”
where “x.x.x.x” is the IP address of one of the IP Phones.
The IP address “x.x.x.x” is the PUBLIC IP address of the IP Phone. If there
are multiple IP Phones using the same public IP address, the output will be
similar to the example shown in Figure 234 on page 727.
Table 95
Voice Gateway commands
IPL> command Description
Signaling
Server
vgwPLLog Toggles gateway packet loss logging on and off.
vgwShow Displays information about the active (non-idle and
equipped) gateway channels.
Entering this command with the IP address of an IP
Phone at the Command Line Interface of any node’s
Voice Gateway Media Card displays the identification
of the card that has a gateway channel in use by the IP
Phone. This information is useful when there is a need
to identify from which card to collect gateway statistics
(for example, packet loss).
vgwShowALL Displays information about all gateway channels.