IP Line 4.5 administration Page 553 of 910
IP Line Description, Installation and Maintenance
To suppress all password prompting to reconfigure the Node ID and TN, clear
the temporary password using the nodeTempPwdClear command. Also,
configure the administrative password to a null password using the
nodePwdSet command with no “password” parameter specified.
Configure the IP Phone Installer Passwords
The IP Phone Installer Passwords are configured on one Voice Gateway
Media Card or on the Signaling Server in the node. The passwords are then
applied to all cards in the node.
Administrative IP Phone Installer Password
The Administrative IP Phone Installer Password is used by the administrator
to install a new IP Phone or change the configuration (node ID and TN) of an
existing IP Phone.
To configure the Administrative IP Phone Installer Password, follow the
steps in Procedure 69.
Procedure 69
Configuring the Administrative IP Phone Installer Password
1Connect to any Voice Gateway Media Card in the node.
2Login to the IPL> CLI and type the nodePwdShow command. This
command displays the settings of the IP Phone Installer (node) password.
If in the default state, the IP Phone Installer Password has never been set.
The nodePwdShow command should display the following:
where:
NodeID – the IP Phone Installer Password configuration applies to all
Voice Gateway Media Cards on the same TLAN that belong to this Node
ID.
PwdEna – by default the cards should be in disabled state (PwdEna=No).
The PwdEna setting specifies the enabled (Yes) or disabled (No) state of
the IP Phone Installer Password.
NodeID
======
123
PwdEna
=======
No
Pwd
========
TmpPwd
========
Uses
=======
Timeout
===========
0d 0h 0m 0s