Page 264 of 910 Personal Directory, Callers List, and Redial List
553-3001-365 Standard 4.00 August 2005
Note: In a node composed of Voice Gateway Media Cards and
Signaling Server(s), IP Phones only register to the Voice Gateway Media
Cards when the Signaling Server(s) are not present due to a failure
condition. Five minutes after a node election is completed, each Voice
Gateway Media Card with IP Phones registered to it checks to see if a
Signaling Server is present in the node. If a Signaling Server is present,
any idle IP Phones that are found are reset (server-switched) back to S1
(Server 1) so they can reregister to the Signaling Server. If an IP Phone
is busy, a one-minute timer is started. Every one minute, the process
comes back to check for idle IP Phones and idle phones are reset. This
checking continues until no IP Phones remain registered to the Voice
Gateway Media Cards.

Configure IP Phone Application Server on a separate

Signaling Server

If the IP Phone Application Server must support more than 1000 users, follow
the steps in Procedure 6 on page 264 to configure the IP Phone Application
Server on a separate Signaling Server.
Procedure 6
Configuring the IP Phone Application Server on a separate Signaling
Server
1In the Element Manager navigator, click IP Telephony > Nodes:
Servers, Media Cards > Configuration to configure a new node.
The Node Configuration window opens. See Figure 45 on page 265.
2Enter a unique Node ID in the New Node field. Click the to Add button.