Administration Commands
define_qllc_ls
If the host supports DDDLU but does not support the NMVT (power off) message, this parameter must be set to NO.
2.45.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.45.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
CANT_MODIFY_PORT_NAME
The ls_name parameter matched the name of an existing LS, but the port_name parameter did not match the existing definition. You cannot modify the port name when changing the definition of an existing LS.
DEF_LINK_INVALID_SECURITY
The security parameter was not set to a valid value.
INVALID_AUTO_ACT_SUPP
The auto_act_supp parameter was not set to a valid value or was set to YES when cp_cp_sess_support was also set to YES.
INVALID_CP_NAME
The adj_cp_name parameter contained a character that was not valid, was not in the correct format, or was not specified when required.
INVALID_LIMITED_RESOURCE
The limited_resource parameter was not set to a valid value.
INVALID_LINK_NAME
The ls_name parameter contained a character that was not valid.
INVALID_NODE_TYPE
The adj_cp_type parameter was not set to a valid value.
INVALID_PORT_NAME
The port_name parameter did not match the name of any defined port.
INVALID_PU_NAME
The pu_name parameter did not match the name of any defined PU, or was set to a new value on an
INVALID_DSPU_NAME
The dspu_name parameter did not match the name of any defined PU or was set to a new value on an
164