Administration Commands
query_focal_point
num_entries
Maximum number of focal point entries for which data should be returned. You can specify 1 to return data for a specific focal point, a number greater than 1 to return data for multiple focal points, or 0 (zero) to return data for all focal points.
list_options
The position in the list of focal points from which SNAplus2 begins to return data.
Possible values are:
FIRST_IN_LIST
Start at the first entry in the list
LIST_INCLUSIVE
Start at the entry specified by the ms_category parameter
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the ms_category parameter
ms_category
Management Services category. This parameter is not used if list_options is set to FIRST_IN_LIST. This category may be one that is specified in Systems Network Architecture: Management Services or a
2.132.2 Returned Parameters
Parameter name | Type | Length |
ms_appl_name | character | 8 |
ms_category | character | 8 |
fp_fqcp_name | character | 17 |
description | character | 31 |
bkup_appl_name | character | 8 |
bkup_fp_fqcp_name | character | 17 |
implicit_appl_name | character | 8 |
implicit_fp_fqcp_name | character | 17 |
fp_type | constant |
|
fp_status | constant |
|
fp_routing | constant |
|
appl_name | character | 8 |
If the command executes successfully, SNAplus2 returns the following parameters:
ms_appl_name
Name of the currently active focal point application. This name is one of the MS
ms_category
Management Services category. This category is one of the category names specified in Systems Network Architecture: Management Services, or a
fp_fqcp_name
Fully qualified control point name of the focal point.
To revoke the existing focal point for the specified MS category, do not specify this parameter.