HP UX Internet and Networking Software manual 17 definedlurdefaults

Administration Commands

define_dlur_defaults

2.17 define_dlur_defaults

The define_dlur_defaults command defines a default Dependent LU Server (DLUS) and a backup default DLUS. If a default DLUS or backup default DLUS is already defined, the command overrides the existing definition. DLUR uses the default DLUS name when it initiates SSCP-PU activation for PUs that do not have an explicitly specified associated DLUS. (To define a PU and its associated DLUS, use define_internal_pu for a local PU, or define_*_ls (for the appropriate link type) for a downstream PU.)

The command can also be used to revoke a default DLUS or backup default DLUS, so that one is not defined.

2.17.1 Supplied Parameters

Parameter name	Type	Length	Default
[define_dlur_defaults]
description	character	31	(null string)
dlus_name	character	17
bkup_dlus_name	character	17	(null string)
dlus_retry_timeout	decimal		5
dlus_retry_limit	decimal		3
prefer_active_dlus	constant

Supplied parameters are:

description

A text string describing the DLUR defaults. SNAplus2 uses this string for information only. It is stored in the node’s configuration file, but SNAplus2 does not make any other use of it.

dlus_name

Name of the DLUS node that is to be the default. Specify 3–17 type-A characters that consist of a 1–8 character network name, followed by a period, followed by a 1–8 character DLUS node name. To revoke the current default DLUS, so that no default DLUS is defined, do not specify this parameter.

bkup_dlus_name

Name of the DLUS node that is to serve as the backup default. Specify 3–17 type-A characters that consist of a 1–8 character network name, followed by a period, followed by a 1–8 character backup DLUS node name. To revoke the current backup default DLUS, so that no backup default DLUS is defined, do not specify this parameter.

dlus_retry_timeout

The interval in seconds between the second and subsequent attempts to contact the DLUS specified by the dlus_name and bkup_dlus_name parameters. The interval between the first and second attempts is always 1 second.

Specify a value in the range 1– 65,535.

dlus_retry_limit

Retry count for contacting a DLUS. This parameter is used to specify the number of times SNAplus2 should retry if it fails to contact the DLUS on the first attempt.

Specify a value in the range 1–65,534, or specify 65,535 to indicate that SNAplus2 should retry indefinitely until it contacts the DLUS.

prefer_active_dlus

Specifies how SNAplus2 operates when it receives a negative RSP(REQACTPU) from DLUS, or is attempting to reactivate a failed DLUR PU. Possible values are:

YES

77