Administration Commands
start_internal_pu
2.195.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_DLUS_NAME
The dlus_name parameter contained a character that was not valid or was not in the correct format.
INVALID_BKUP_DLUS_NAME
The bkup_dlus_name parameter contained a character that was not valid or was not in the correct format.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
NO_DEFAULT_DLUS_DEFINED
A DLUS name was not specified either on this command or on define_internal_pu, and there is no default DLUS defined (because define_dlur_defaults has not been issued).
PU_NOT_DEFINED
The supplied PU name was not the name of an internal PU defined using define_internal_pu.
PU_ALREADY_ACTIVATING
The PU is already being activated.
PU_ALREADY_ACTIVE
The PU has already been activated.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The node does not support DLUR; support is defined by the dlur_support parameter on the define_node command.
secondary_rc
(This parameter is not used.)
Other Conditions
If the command does not execute because other conditions exist, SNAplus2 returns the following parameters:
