Administration Commands
define_qllc_ls
bkup_dlus_name
Name of the backup DLUS node from which DLUR solicits SSCP services if the node specified by dlus_name is not active. This parameter is reserved if dspu_services is not set to DLUR.
Specify
To specify the global backup default DLUS, defined using define_dlur_defaults, do not specify this parameter.
hpr_supported
Specifies whether HPR is supported on this link. This parameter must be set to NO unless the adj_cp_type parameter indicates that the link connects to an APPN node. Possible values are:
YES
HPR is supported on this link.
NO
HPR is not supported on this link.
link_deact_timer
Limited resource link deactivation timer, in seconds. A limited resource link is automatically deactivated if no data flows over the link for the time specified by this parameter. This parameter is not used if limited_resource is set to any value other than INACTIVITY.
The minimum value is 5; values in the range
The value 0 (zero) indicates one of the following:
•If the hpr_supported parameter is set to YES, the default deactivation timer value of 30 is used.
•If the hpr_supported parameter is set to NO, no timeout is used (the link is not deactivated, as if lim- ited_resource were set to NO).
default_nn_server
For an end node this parameter specifies whether the link handled by this link station is a link supporting
Possible values are:
YES
This link supports
NO
This link should not be automatically activated when an attempt is made to contact an NN server.
If the local node is not an end node, this parameter is ignored. If the local node is not an end node, this parameter is ignored.
ls_attributes
Attributes of the remote system with which SNAplus2 is communicating.
Specify SNA unless you are communicating with a host of another type. Possible values are:
156