Administration Commands
query_conversation
2.109.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_CN_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied name, but the value specified in the fqcn_name parameter was not valid.
INVALID_PORT_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied name, but the value specified in the port_name parameter was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node is a LEN node. This command is valid only at a network node or an end node.
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.110 query_conversation
The query_conversation command returns information about conversations using a particular local LU. This command can be used to obtain information about a specific conversation or a range of conversations, depending on the options used.
This command must be issued to a running node.
2.110.1 Supplied Parameters
Parameter name | Type | Length | Default |
[query_conversation]
