Administration Commands
define_qllc_ls
If the adjacent node is not an APPN node, possible values are:
BACK_LEVEL_LEN_NODE
The adjacent node is one that does not include the Network Name control vector in its XID3.
HOST_XID3
The adjacent node is a host node; SNAplus2 responds to a polling XID from the node with a format 3 XID.
HOST_XID0
The adjacent node is a host node; SNAplus2 responds to a polling XID from the node with a format 0 XID.
DSPU_XID
The adjacent node is a downstream PU; SNAplus2 includes XID exchange in link activation. The dspu_name and dspu_services parameters must also be set.
DSPU_NOXID
The adjacent node is a downstream PU; SNAplus2 does not include XID exchange in link activation. The dspu_name and dspu_services parameters must also be set.
If you want to run independent LU 6.2 traffic over this LS, you must set the adj_cp_type parameter to LEARN_NODE, END_NODE, NETWORK_NODE, or BACK_LEVEL_LEN_NODE.
address
Destination address of the remote link station. This parameter is used only for SVC outgoing calls (defined by the vc_type parameter and by the link activation limit parameters on define_qllc_port); it is ignored for incoming calls or for PVC.
The address is a string of
auto_act_supp
Specifies whether the link can be automatically activated when required by a session. Possible values are:
YES
The link can be automatically activated.
The reactivation timer parameters are ignored. If the LS fails, SNAplus2 does not attempt to reactivate it until a dependent LU application that was using the session attempts to restart the session; an LS used by independent LUs is not reactivated by SNAplus2 and must be manually restarted.
The following restrictions also apply:
•If the link is to an APPN node, the LS must have a preassigned TG number defined (see the tg_number parameter), and cp_cp_sess_support must be set to NO.
•If either the local node or the adjacent node is an end node, the LS must also be defined to automatically activate at the adjacent node.
NO
The link cannot be automatically activated.
tg_number
Preassigned TG number. This parameter is used only if the adjacent node is an APPN node (adj_cp_type is either NETWORK_NODE or END_NODE); it is ignored otherwise.
153
