Administration Commands
query_dlur_pu
PENDING_ACTIVE
The pipe is being activated.
ACTIVE
The pipe is active.
PENDING_INACTIVE
The pipe is being deactivated.
INACTIVE
The pipe is not active.
pcid
Procedure correlator ID (PCID) used on the DLUS pipe. If the
fqcp_name
Fully qualified control point name used on the DLUS pipe. If the
The combination of the pcid and fqcp_name parameters uniquely identifies each PU whose sessions are being routed using DLUR. The fqcp_name parameter is the CP name of either the DLUR or DLUS node, depending on which node initiated the
initially_active
Specifies whether this PU is automatically started when the node is started. For a downstream PU, this parameter is not used. Possible values for an internal PU are:
YES
The PU is automatically started when the node is started.
NO
The PU is not automatically started; it must be manually started.
dlus_retry_timeout
Time interval in seconds between attempts to contact the DLUS and backup DLUS. A value of 0 (zero) indicates that the value from the define_dlur_defaults command is used.
dlus_retry_limit
Number of attempts to recontact a DLUS after an initial failure. A value of 0 (zero) indicates that the value from the define_dlur_defaults command is used.
2.125.4 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_PU_NAME
364
