Administration Commands
query_rtp_tuning
1
YELLOW
2
RED
route
Route Selection Control Vector (RSCV) as defined by SNA Formats. This control vector defines the session route through the network and is carried on the BIND. This RSCV is included only if the node’s configuration (specified using define_node) indicates that endpoint RSCVs should be stored.
2.165.4 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_RTP_CONNECTION
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied name, but the rtp_name parameter was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.166 query_rtp_tuning
The query_rtp_tuning command returns information about the parameters that will be used for future RTP connections. This information was previously set up using define_rtp_tuning.
2.166.1 Supplied Parameters
[query_rtp_tuning]
No parameters are supplied for this command.
2.166.2 Returned Parameters
Parameter name | Type | Length |
path_switch_attempts decimal
527
