Administration Commands
query_ls
Primary
LS_SEC
Secondary
LS_NEG
Negotiable
max_ifrm_rcvd
Maximum number of
dlus_retry_timeout
Time interval in seconds between attempts to contact the DLUS and backup DLUS.
dlus_retry_limit
Number of attempts to recontact a DLUS after an initial failure.
branch_link_type
This parameter applies only if the local node is a Branch Network Node; it is reserved if the local node is any other type.
If the parameter adj_cp_type is set to NETWORK_NODE, END_NODE, APPN_NODE, or BACK_LEVEL_LEN_NODE, this parameter defines whether the link is an uplink or a downlink. Possible values are:
UPLINK
The link is an uplink.
DOWNLINK
The link is a downlink.
adj_brnn_cp_support
This parameter applies only if the local node is a Branch Network Node and the adjacent node is a network node (the parameter adj_cp_type is set to NETWORK_NODE, or it is set to APPN_NODE and the node type discovered during XID exchange is network node). It is reserved if the local and remote nodes are any other type.
This parameter defines whether the adjacent node can be a Branch Network Node that is acting as a Network Node from the point of view of the local node. Possible values are:
ALLOWED
The adjacent node is allowed (but not required) to be a Branch Network Node.
REQUIRED
The adjacent node must be a Branch Network Node.
PROHIBITED
The adjacent node must not be a Branch Network Node.
dddlu_offline_supported
Specifies whether the local PU should send NMVT (power off) messages to the host. If the host system supports DDDLU (Dynamic Definition of Dependent LUs), SNAplus2 sends NMVT (power off) to the host when it has finished using a dynamically defined LU. This allows the host to save resources by removing the definition when it is no longer required.
This parameter is used only if this link is to a host (solicit_sscp_sessions is set to YES and dspu_services is not set to NONE).
