HP UX Internet and Networking Software manual Plumodesessionlimit, Minconwinnerssource, Autoact

Administration Commands

change_session_limit

NO

Leave the maximum negotiable session limit as the value specified for the mode.

plu_mode_session_limit

Requested total session limit for this LU-LU-mode combination—the maximum number of parallel sessions allowed between these two LUs using this mode. This value can be negotiated with the partner LU. Specify a value in the range 1–32,767(which must not exceed the session limit specified for the local LU on the define_local_lu command). To specify a value of 0 (zero) use the reset_session_limit command.

min_conwinners_source

Minimum number of sessions using this mode for which the local LU is the contention winner. The sum of the min_conwinners_source and min_conwinners_target parameters must not exceed the plu_mode_session_limit parameter. Specify a value in the range 0–32,767.

min_conwinners_target

Minimum number of sessions using this mode for which the partner LU is the contention winner. The sum of the min_conwinners_source and min_conwinners_target parameters must not exceed the plu_mode_session_limit parameter. Specify a value in the range 0–32,767.

auto_act
Number of sessions to activate automatically after	the	session limit	is changed. The actual	number
of automatically activated sessions is the minimum	of	this value and	the negotiated minimum	number

of contention winner sessions for the local LU. When sessions are deactivated normally (specifying DEACT_NORMAL for the type parameter on deactivate_session) this limit, new sessions are activated up to this limit. Specify a value in the range 0–32,767(which must not exceed the plu_mode_session_limit parameter or the session limit specified for the local LU on the define_local_lu command).

responsible

Indicates whether the local LU or partner LU is responsible for deactivating sessions after the session limit is changed. Possible values are:

SOURCE

The local LU is responsible for deactivating sessions after the session limit has been changed.

TARGET

The partner LU is responsible for deactivating sessions after the session limit has been changed.

2.5.2 Returned Parameters

If the command executes successfully, the following parameters are returned:

primary_rc

OK

secondary_rc

Possible values are:

AS_NEGOTIATED

The session limits were changed, but one or more values were negotiated by the partner LU.

AS_SPECIFIED

The session limits were changed as requested, without being negotiated by the partner LU.

50