HP UX Internet and Networking Software manual Implicitdspuservices, Lsxmitrcvcap

Administration Commands

define_qllc_port

If the implicit_dspu_services parameter is not set to PU_CONCENTRATION, the implicit_dspu_template parameter is reserved.

implicit_ls_limit

Specifies the maximum number of implicit link stations which can be active on this port simultaneously, including dynamic links and links activated for Discovery. Specify a value in the range 1–65,534or specify 0 (zero) to indicate no limit. A value of NO_IMPLICIT_LINKS indicates that no implicit links are allowed.

implicit_dspu_services

Specifies the services that the local node will provide to the downstream PU across implicit links activated on this port. Possible values are:

DLUR

Local node will provide DLUR services for the downstream PU (using the default DLUS configured through the define_dlur_defaults command).

PU_CONCENTRATION

Local node will provide PU concentration for the downstream PU. It will also put in place definitions as specified by the DSPU template specified for the parameter implicit_dspu_template.

NONE

Local node will provide no services for this downstream PU.

implicit_deact_timer

Implicit limited resource link deactivation timer, in seconds.

If implicit_hpr_support is set to YES and implicit_limited_resource is set to NO_SESSIONS, an implicit link is automatically deactivated if no data flows on it for the time specified by this parameter and no sessions are using the link.

If implicit_limited_resource is set to INACTIVITY, an implicit link using this port is automatically deacti- vated if no data flows on it for the time specified by this parameter.

The minimum value is 5; values in the range 1–4will be interpreted as 5. The value 0 (zero) indicates no timeout (the link is not deactivated, as though implicit_limited_resource were set to NO). This parameter is reserved if implicit_limited_resource is set to NO.

implicit_uplink_to_en

This parameter applies only if the local node is a Branch Network Node; it is reserved if the local node is any other type.

If the adjacent node is an end node, this parameter specifies whether implicit link stations off this port are uplink or downlink. This parameter is ignored if there are existing links to the same adjacent node, because in this case the existing links are used to determine the link type. Possible values are:

YES

Implicit links to an End Node are uplinks.

NO

Implicit links to an End Node are downlinks.

act_xid_exchange_limit

Activation XID exchange limit. Specify a value in the range 0–65,535.

nonact_xid_exchange_limit

Nonactivation XID exchange limit. Specify a value in the range 0–65,535.

ls_xmit_rcv_cap

169