Administration Commands

reset_session_limit

YES

Reset the maximum negotiable session limit for this LU-LU-mode combination to 0 (so that sessions cannot be activated until the limit is changed by initialize_session_limit).

NO

Leave the maximum negotiable session limit unchanged.

responsible

Indicates whether the source (local) or target (partner) LU is responsible for deactivating sessions after the session limit is reset. Possible values are:

SOURCE

The local LU is responsible for deactivating sessions.

TARGET

The partner LU is responsible for deactivating sessions.

drain_source

Specifies whether the source LU satisfies waiting session requests before deactivating a session. Possible values are:

YES

Waiting session requests are satisfied.

NO

Waiting session requests are not satisfied.

drain_target

Specifies whether the target LU satisfies waiting session requests before deactivating a session. Possible values are:

YES

Waiting session requests are satisfied.

NO

Waiting session requests are not satisfied.

force

Specifies whether to set session limits to 0 even if CNOS negotiation fails. Possible values are:

YES

Set session limits to 0.

NO

Do not set session limits to 0 even if CNOS negotiation fails.

2.182.2 Returned Parameters

If the command executes successfully, SNAplus2 returns the following parameters:

primary_rc

OK

secondary_rc

576

Page 576
Image 576
HP UX Internet and Networking Software manual Draintarget, Force