Administration Commands
query_dlus
actlu_received
Number of ACTLUs received from DLUS over the pipe to activate an LU.
actlu_rsp_sent
Number of RSP(ACTLU)s sent to DLUS over the pipe.
dactlu_received
Number of DACTLUs received from DLUS over the pipe to deactivate an LU.
dactlu_rsp_sent
Number of RSP(DACTLU)s sent to DLUS over the pipe.
sscp_pu_mus_rcvd
Number of
sscp_pu_mus_sent
Number of
sscp_lu_mus_rcvd
Number of
sscp_lu_mus_sent
Number of
2.126.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_DLUS_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied name, but the dlus_name parameter value was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node does not support DLUR; this support is defined by the dlur_support parameter on the define_node command.
368