HP UX Internet and Networking Software manual Actxidexchangelimit

Administration Commands

define_sdlc_port

Primary

LS_SEC

Secondary

LS_NEG

Negotiable

act_xid_exchange_limit

Activation XID exchange limit. Specify a value in the range 1–65,535.

nonact_xid_exchange_limit

Nonactivation XID exchange limit. Specify a value in the range 1–65,535.

ls_xmit_rcv_cap

Specifies the link station transmit/receive capability. Possible values are:

LS_TWS

Two-way simultaneous

LS_TWA

Two-way alternating

max_ifrm_rcvd

Maximum number of I-frames that can be received by the local link stations before an acknowledgment is sent. Specify a value in the range 1–127.

target_pacing_count

Indicates the desired pacing window size. Specify a value in the range 1–32,767.

max_send_btu_size

Maximum BTU size that can be sent from this port. This value is used to negotiate the maximum BTU size that a pair of link stations can use to communicate with each other. The value includes the length of the TH and RH (total 9 bytes), as well as the RU. Specify a value in the range 265–4105.

address

Port address used for incoming calls.

The value of this parameter depends on how the port that owns this LS is configured, as follows:

•If the port is used only for incoming calls, or if ls_role is set to LS_PRI, or if ls_role is set to LS_NEG and the local station becomes primary after LS role negotiation, this parameter is reserved.

•If ls_role is set to LS_SEC, or if ls_role is set to LS_NEG and the local station becomes secondary after LS role negotiation, this address is used in the response to an incoming call.

If the address of the remote station is unknown, set this parameter to zero.

implicit_cp_cp_sess_support

Specifies whether CP-CP sessions are allowed for implicit link stations using this port. Possible values are:

YES

CP-CP sessions are allowed for implicit link stations.

NO

CP-CP sessions are not allowed for implicit link stations.

202