Administration Commands
define_qllc_ls
The adjacent node must be a Branch Network Node.
PROHIBITED
The adjacent node must not be a Branch Network Node.
If adj_cp_type is set to NETWORK_NODE and auto_act_supp is set to YES, this parameter must be set to REQUIRED or PROHIBITED.
max_send_btu_size
Maximum BTU size that can be sent from this link station. This value is used to negotiate the maximum BTU size that a pair of link stations can use to communicate with each other. The value includes the length of the TH and RH (total 9 bytes), as well as the RU. Specify a value in the range
ls_role
Link station role. This parameter is usually set to USE_PORT_DEFAULTS, specifying that the LS role is to be taken from the definition of the port that owns this LS.
If you need to override the port’s LS role for an individual LS, specify one of the following values:
LS_PRI
Primary
LS_SEC
Secondary
LS_NEG
Negotiable
initially_active
Specifies whether this LS is automatically started when the node is started. Possible values are:
YES
The LS is automatically started when the node is started.
NO
The LS is not automatically started; it must be manually started.
If the LS is a PVC link, you are recommended to set this parameter to YES to ensure that the link is always available.
react_timer
Reactivation timer for reactivating a failed LS. This parameter specifies the amount of time (in seconds) that SNAplus2 should wait before retrying to activate the LS that failed. If the react_timer_retry parameter is a nonzero value, then SNAplus2 should retry activating the LS if it fails. If react_timer_retry parameter value is zero, this parameter is ignored.
react_timer_retry
Retry count for reactivating a failed LS. This parameter is used to specify whether SNAplus2 attempts to reactivate the LS if it fails while in use (or if an attempt to start the LS fails).
Specify 0 (zero) to indicate that SNAplus2 should not attempt to reactivate the LS. Specify the number of retries to be made to indicate that SNAplus2 should attempt to reactivate the LS. A value of 65,535 indicates that SNAplus2 should retry indefinitely until the LS is reactivated.
SNAplus2 waits for the time specified by the react_timer parameter between successive retries. If the LS is not successfully reactivated by the end of the retry count, or if stop_ls is issued while SNAplus2 is retrying the activation, no further retries are made; the LS remains inactive unless start_ls is issued for it.
160