Administration Commands
define_lu_0_to_3_range
Possible values are:
INVALID_LU_NAME
The lu_name parameter contained a character that was not valid.
INVALID_POOL_NAME
The pool_name parameter contained a character that was not valid.
INVALID_NAU_ADDRESS
The nau_address parameter was not in the valid range.
INVALID_PRIORITY
The priority parameter was not set to a valid value.
INVALID_TERM_METHOD
The term_method parameter was not set to a valid value.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
INVALID_PU_NAME
The value specified in the pu_name parameter was not valid.
PU_NOT_DEFINED
The pu_name parameter did not match any defined PU name.
INVALID_PU_TYPE
The PU specified by the pu_name parameter is not a host PU.
LU_NAME_POOL_NAME_CLASH
The LU name matches the name of an LU pool.
LU_ALREADY_DEFD
An LU with the specified name has already been defined.
LU_NAU_ADDR_ALREADY_DEFD
An LU with the specified NAU address has already been defined.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.37 define_lu_0_to_3_range
The define_lu_0_to_3_range command defines a range of LUs for use with 3270 emulation, RJEor LUA (LUs of type 0, 1, 2, or 3), and optionally assigns the LUs to an LU pool. This command cannot be used to modify existing LUs.
125
