HP UX Internet and Networking Software manual 424

Administration Commands

query_ls

YES

The LS can be activated only by the local node; if the remote node attempts to activate it, SNAplus2 will reject the attempt.

NO

The LS can be activated by the remote node.

default_nn_server

For an end node, this parameter specifies whether this is a link supporting CP-CP sessions to a network node that can act as the local node’s network node server. When the local node has no CP-CP sessions to a network node server and needs to establish them, the local node checks this parameter on its defined link stations to find a suitable LS to activate. This enables you to specify which adjacent NNs are suitable to act as the NN server (for example, to avoid using NNs that are accessed by expensive or slow links).

Possible values are:

YES

This link supports CP-CP sessions to a network node that can act as the local node’s NN server; the local node can automatically activate this link if it needs to contact an NN server.

NO

This link does not support CP-CP sessions to a network node that can act as the local node’s NN server; the local node cannot automatically activate this link if it needs to contact an NN server.

If the local node is not an end node, this parameter is not used.

hpr_supported

Specifies whether HPR is supported on this link. Possible values are:

YES

HPR is supported on this link.

NO

HPR is not supported on this link.

hpr_link_lvl_error

Specifies whether HPR traffic should be sent on this link using link-level error recovery. This parameter should be ignored unless hpr_supported is set to YES. Possible values are:

YES

HPR traffic should be sent on this link using link-level error recovery.

NO

HPR traffic should not be sent on this link using link-level error recovery.

link_deact_timer

Limited resource link deactivation timer, in seconds. A limited resource link is automatically deactivated if not data flows over the link for the time specified by this parameter. This parameter is not used if limited_resource is set to any value other than INACTIVITY.

use_default_tg_chars

Specifies whether the default TG characteristics supplied in the port definition are used. Possible values are:

YES

Use the default TG characteristics; ignore effect_cap through user_def_parm_3 parameters on this command.

424