Administration Commands
define_local_lu
secondary_rc
Possible values are:
PORT_ACTIVE
The specified port cannot be modified because it is currently active.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.33.4 Incoming Calls
If you are configuring a port that accepts incoming calls (as defined by the tot_link_act_lim, inb_link_act_lim, and out_link_act_lim parameters), there is no need to define an LS to use for these calls; SNAplus2 will dynamically define an LS when the incoming call is received.
When an incoming call arrives at the port, SNAplus2 checks the address specified on the call against the addresses specified for link stations defined on the port (if any) to determine if an LS has already been defined for the call. If the address does not match, an LS is dynamically defined. To ensure that the explicit LS definition is used, be sure that the address defined for this LS matches the address that is supplied by the remote computer on the incoming call.
2.34 define_local_lu
The define_local_lu command defines a new local LU. The command can also be used to modify the disable, description, sys_name, timeout, or back_level parameters for an existing LU or for the default LU associated with the local node’s control point, but it cannot modify any of the other parameters. When modifying an existing LU, all the other parameters that cannot be modified must be set to their currently defined values.
2.34.1 Supplied Parameters
Parameter name | Type | Length | Default |
[define_local_lu] |
|
|
|
lu_name | character | 8 |
|
description | character | 31 | (null string) |
list_name | character | 14 | (null string) |
lu_alias | character | 8 |
|
nau_address | decimal |
| 0 |
syncpt_support | constant |
| NO |
lu_session_limit | decimal |
| 0 |
default_pool | constant |
| NO |
pu_name | character | 8 | (null string) |
lu_attributes | constant |
| NONE |
sscp_id | decimal |
| 0 |
disable | constant |
| NO |
sys_name | character | 128 | (null string) |
timeout | decimal |
| 60 |
back_level | constant |
| NO |
Supplied parameters are:
lu_name
116