HP UX Internet and Networking Software manual Adjnodeid

Administration Commands

define_sdlc_ls

HNA

Hitachi Network Architecture host

SUPPRESS_CP_NAME

Suppress the CP name associated with the remote node. Use a + character to combine this value with SNA, FNA, or HNA.

If adj_cp_type is set to BACK_LEVEL_LEN_NODE, and the remote LEN node associated with this LS cannot accept the Network Name CV in the format 3 XID it receives, use a + character to combine the value SNA, FNA, or HNA with SUPPRESS_CP_NAME (for example, SNA+SUPPRESS_CP_NAME).

If adj_cp_type is set to any other value, the SUPPRESS_CP_NAME option is ignored.

adj_node_id

Node ID of adjacent node. This ID is a 4-byte hexadecimal string, consisting of a block number (three hexadecimal digits) and a node number (five hexadecimal digits). To disable node ID checking, do not specify this parameter. If this link station is defined on a switched port, the adj_node_id must be unique, and there may only be one null adj_node_id on each switched port.

local_node_id

Node ID sent in XIDs on this LS. This ID is a 4-byte hexadecimal string, consisting of a block number (three hexadecimal digits) and a node number (five hexadecimal digits). To use the node ID specified in the node_id parameter on the define_node command, do not specify this parameter.

cp_cp_sess_support

Specifies whether CP-CP sessions are supported. This parameter is valid only if the adjacent node is an end node or a network node (adj_cp_type is NETWORK_NODE, END_NODE, or LEARN_NODE); it is ignored otherwise. If both the local node and the adjacent node are network nodes, this parameter should be set to YES in order to use APPN functions between these nodes.

Possible values are:

YES

CP-CP sessions are supported. The solicit_sscp_sessions parameter must be set to NO.

NO

CP-CP sessions are not supported.

use_default_tg_chars

Specifies whether to use the default TG characteristics supplied on define_sdlc_port. The TG characteristics apply only if the link is to an APPN node. If the link is not to an APPN node, the use_default_tg_chars through user_def_parm_3 parameters are ignored. Possible values are:

YES

Use the default TG characteristics; ignore the effect_cap through user_def_parm_3 parameters on this command.

NO

Use the effect_cap through user_def_parm_3 parameters on this command.

effect_cap

A decimal value representing the line speed in bits per second.

connect_cost

Cost per connect time. Valid values are integer values in the range 0–255, where 0 is the lowest cost per connect time and 255 is the highest cost per connect time.

188