HP UX Internet and Networking Software Minuserdefparm1 through minuserdefparm3, Maxeffectcap

Administration Commands

define_cos

PROP_DELAY_PKT_SWITCHED_NET

Delay is in the range 50–250 microseconds (typical for a packet-switched network).

PROP_DELAY_SATELLITE

Delay is greater than 250 microseconds (typical for a satellite link).

PROP_DELAY_MAXIMUM

Maximum propagation delay.

min_user_def_parm_1 through min_user_def_parm_3

Minimum limits for user-defined parameters, which you can use to include TG characteristics not covered by previously defined parameters. Each of these parameters must be set to a value in the range 0–255.

max_effect_cap

Maximum limit for actual bits per second rate (line speed). Specify a value in the range 0– 603,979,776,000.

max_connect_cost

Maximum limit for cost per connect time. Valid values are integer values in the range 0–255, where 0 is the lowest cost per connect time and 255 is the highest cost per connect time.

max_byte_cost

Maximum limit for cost per byte. Valid values are integer values in the range 0–255, where 0 is the lowest cost per byte and 255 is the highest cost per byte.

max_security

Maximum level of security. Possible values are:

SEC_NONSECURE

Data is transmitted over an unsecured network.

SEC_PUBLIC_SWITCHED_NETWORK

Data is transmitted over a public-switched network.

SEC_UNDERGROUND_CABLE

Data is transmitted over secure underground cable.

SEC_SECURE_CONDUIT

Data is transmitted over a line in a secure conduit that is not guarded.

SEC_GUARDED_CONDUIT

Data is transmitted over a line in a conduit that is protected against physical tapping.

SEC_ENCRYPTED

Data is encrypted before transmission over the line.

SEC_GUARDED_RADIATION

Data is transmitted over a line that is protected against physical and radiation tapping.

max_prop_delay

Maximum limits for propagation delay, which is the time that a signal takes to travel the length of the link. Specify one of the following values, according to the type of link:

67