Administration Commands
define_qllc_ls
The DLC is automatically started when the node is started.
NO
The DLC is automatically started only if a port or LS that uses it is defined as initially active; otherwise, it must be manually started.
2.44.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.44.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
INVALID_DLC_NAME
The supplied dlc_name parameter contained a character that was not valid.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
DLC_ACTIVE
The DLC cannot be modified because it is currently active.
NVALID_DLC_TYPE
You cannot change the negotiable link support for an existing DLC. This parameter can be specified only when creating a new DLC.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.45 define_qllc_ls
The define_qllc_ls command is used to define a new QLLC link station (LS) or modify an existing one. Before issuing this command, you must define the port that this LS uses.
150
