Administration Commands
query_downstream_lu
If the downstream LU is used to communicate with a SNAplus2 Primary RUI application instead of a host, this field is set to the string #PRIRUI#.
This parameter is reserved for
allow_timeout
Specifies whether this downstream LU allows its session with the upstream LU to timeout. Possible values are:
YES
This downstream LU allows its session with the upstream LU to timeout.
NO
This downstream LU does not allow its session with the upstream LU to timeout.
This field is ignored if the downstream LU is used to communicate with a SNAplus2 Primary RUI application instead of a host.
delayed_logon
Specifies whether this downstream LU uses delayed logon (the upstream LU is not activated until the user requests that it be activated). Possible values are:
YES
This downstream LU uses delayed logon.
NO
This downstream LU does not use delayed logon.
This field is ignored if the downstream LU is used to communicate with a SNAplus2 Primary RUI application instead of a host.
2.128.4 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_LU_NAME
The list_options parameter was set to LIST_INCLUSIVE to list all entries starting from the supplied name, but the value specified in the lu_name parameter was not valid.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the following parameter:
