Administration Commands

define_sdlc_ls

The adjacent node must be a Branch Network Node.

PROHIBITED

The adjacent node must not be a Branch Network Node.

If adj_cp_type is set to NETWORK_NODE and auto_act_supp is set to YES, this parameter must be set to REQUIRED or PROHIBITED.

dddlu_offline_supported

Specifies whether the local PU should send NMVT (power off) messages to the host. If the host system supports DDDLU (Dynamic Definition of Dependent LUs), SNAplus2 sends NMVT (power off) to the host when it has finished using a dynamically defined LU. This allows the host to save resources by removing the definition when it is no longer required.

This parameter is used only if this link is to a host (solicit_sscp_sessions is set to YES and dspu_services is not set to NONE).

Possible values are:

YES

The local PU sends NMVT (power off) messages to the host.

NO

The local PU does not send NMVT (power off) messages to the host.

If the host supports DDDLU but does not support the NMVT (power off) message, this parameter must be set to NO.

2.51.2 Returned Parameters

No parameters are returned by SNAplus2 when this command executes successfully.

2.51.3 Error Return Codes

If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.

Parameter Check

If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:

primary_rc

PARAMETER_CHECK

secondary_rc

Possible values are:

CANT_MODIFY_PORT_NAME

The ls_name parameter matched the name of an existing LS, but the port_name parameter did not match the existing definition. You cannot modify the port name when changing the definition of an existing LS.

DEF_LINK_INVALID_SECURITY

The security parameter was not set to a valid value.

INVALID_AUTO_ACT_SUPP

The auto_act_supp parameter was not set to a valid value or was set to YES when cp_cp_sess_support was also set to YES.

195

Page 195
Image 195
HP UX Internet and Networking Software manual Returned Parameters