Administration Commands
set_trace_type
The types of tracing required. For more information about these trace types, refer to
If init_flags is set to YES, select the values corresponding to the interfaces where you want tracing to be active, and do not select the values corresponding to the interfaces where you want it to be inactive. If init_flags is set to NO, select the values corresponding to the interfaces where you want to change the state of tracing.
To set tracing for all types of messages use one of the following values:
NONE
Do not activate tracing for any type of messages.
ALL
Activate tracing for all types of messages.
To set tracing for a specific interface, use one or more of the following values (combined using + characters).
APPC
Trace APPC messages
FM
Trace FM messages
LUA
Trace LUA messages
NOF
Trace NOF messages
MS
Trace MS messages
PV
Trace APPC and
DLPI
Trace DLPI messages
SDLC
Trace SDLC messages (note that this option also provides additional detail in SDLC line tracing)
NLI
Trace NLI messages
IPDLC
Trace Enterprise Extender (HPR/IP) messages
NDLC
Trace node to DLC messages
NODE
Trace node internal messages
SLIM
Trace messages sent between servers in a
597