Administration Commands
query_dlus
Maximum number of DLUSs for which data should be returned. You can specify 1 to return data for a specific DLUS, a number greater than 1 to return data for multiple DLUSs, or 0 (zero) to return data for all DLUSs.
list_options
The position in the list of DLUSs from which SNAplus2 begins to return data. The list is ordered by dlus_name.
Possible values are:
FIRST_IN_LIST
Start at the first entry in the list
LIST_INCLUSIVE
Start at the entry specified by the dlus_name parameter
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the dlus_name parameter
dlus_name
Name of the DLUS for which information is required, or the name to be used as an index into the list of DLUSs. This value is ignored if list_options is set to FIRST_IN_LIST. Specify
2.126.2 Returned Parameters
Parameter name | Type | Length |
dlus_name | character | 17 |
is_default | constant |
|
is_backup_default | constant |
|
pipe_state | constant |
|
num_active_pus | decimal |
|
reqactpu_sent | decimal |
|
reqactpu_rsp_received | decimal |
|
actpu_received | decimal |
|
actpu_rsp_sent | decimal |
|
reqdactpu_sent | decimal |
|
reqdactpu_rsp_received | decimal |
|
dactpu_received | decimal |
|
dactpu_rsp_sent | decimal |
|
actlu_received | decimal |
|
actlu_rsp_sent | decimal |
|
dactlu_received | decimal |
|
dactlu_rsp_sent | decimal |
|
sscp_pu_mus_rcvd | decimal |
|
sscp_pu_mus_sent | decimal |
|
sscp_lu_mus_rcvd | decimal |
|
sscp_lu_mus_sent | decimal |
|
If the command executes successfully, SNAplus2 returns the following parameters:
dlus_name
Name of the DLUS.
is_default
Specifies whether the DLUS node has been designated as the default by a define_dlur_defaults command. Possible values are:
366