Administration Commands
define_dspu_template
STATE_CHECK
secondary_rc
Possible values are:
INVALID_PU_NAME
The specified dspu_name parameter value was not valid.
PU_NOT_DEFINED
The specified dspu_name parameter did not match any defined PU name.
INVALID_PU_TYPE
The PU specified by the dspu_name parameter is not a downstream PU that supports PU concentration.
LU_ALREADY_DEFINED
An LU has already been defined with a name that matches one of the names in the range. The existing LU cannot be modified using this command.
DSLU_ACTIVE
An LU with a name that matches one of the names in the range is already active. The existing LU cannot be modified using this command.
LU_NAU_ADDR_ALREADY_DEFD
An LU has already been defined with an NAU address that matches one of the addresses in the range.
INVALID_HOST_LU_NAME
The specified host_lu_name parameter value was not valid.
LU_NAME_POOL_NAME_CLASH
One of the LU names in the range matches the name of an existing LU pool.
Function Not Supported
If the command does not execute because the node’s configuration does not support it, SNAplus2 returns the following parameters:
primary_rc
FUNCTION_NOT_SUPPORTED
The local node does not support PU concentration; this support is defined by the pu_conc_support parameter on the define_node command.
secondary_rc
(This parameter is not used.)
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.21 define_dspu_template
The define_dspu_template command defines a template for the downstream LUs that use the SNAplus2 PU concentration feature. This template is used to define downstream LUs on a group of downstream workstations when a workstation connects over an implicit link (a link not previously defined)..
85
