HP UX Internet and Networking Software manual Pulocation, Activedlusname, Anssupport, Pustatus

Administration Commands

query_dlur_pu

Name of the backup DLUS node, defined by either the define_internal_pu or define_*_ls command (with dspu_services set to DLUR).

pu_id

PU identifier, either defined on define_internal_pu or obtained in an XID from a downstream PU. This ID is a 4-byte hexadecimal string, consisting of a block number (three hexadecimal digits) and a node number (five hexadecimal digits).

pu_location

Location of the PU.

Possible values are:

INTERNAL

The PU is on the local node.

DOWNSTREAM

The PU is on a downstream node (network node only).

active_dlus_name

Name of the DLUS node that the PU is currently using. If the SSCP-PU session is not active, this parameter is not returned.

ans_support

Auto network shutdown (ANS) support, defined by the DLUS and sent to DLUR from the DLUS at SSCP-PU activation. This parameter specifies whether to continue link-level contact if the subarea node initiates an auto network shutdown procedure for the SSCP controlling the PU. Possible values are:

CONT

Continue link-level contact.

STOP

Stop link-level contact.

This parameter is reserved if the SSCP-LU session is inactive.

pu_status

Status of the PU (associated with DLUR). Possible values are:

RESET

The PU is in reset state.

PEND_ACTPU

The PU is waiting for an ACTPU from the host.

PEND_ACTPU_RSP

DLUR is waiting for the PU to respond to a forwarded ACTPU.

ACTIVE

The PU is active.

PEND_DACTPU_RSP

DLUR is waiting for the PU to respond to a forwarded DACTPU.

PEND_INOP

DLUR is waiting for all necessary events to be completed before it deactivates the PU.

dlus_session_status

Status of the DLUS pipe currently being used by the PU. Possible values are:

363