
Administration Commands
reset_session_limit
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_RESOURCE_TYPE
The value specified in the resource_type parameter was not valid.
INVALID_MESSAGE_TYPE
The value specified in the message_type parameter was not valid.
INVALID_DLC_NAME
The DLC named in resource_name does not have any tracing options set.
INVALID_PORT_NAME
The port named in resource_name does not have any tracing options set.
INVALID_LS_NAME
The LS named in resource_name does not have any tracing options set.
INVALID_RTP_CONNECTION
The RTP connection named in the resource_name parameter does not have any tracing options set.
INVALID_LFSID_SPECIFIED
The LS named in resource_name does not have any tracing options set for the specified LFSID.
INVALID_FILTER_TYPE
The message_type parameter specified a message type that is not currently being traced for the speci- fied resource.
ALL_RESOURCES_NOT_DEFINED
The resource_type parameter was set to ALL_RESOURCES, but a DLC_TRACE entry has not been defined for tracing options on all resources.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.182 reset_session_limit
The reset_session_limit command requests SNAplus2 to reset the session limits for a particular
574