HP UX Internet and Networking Software manual Puconcsupport, Nnrar, Maxlsexceptionevents, Ptfflags

Administration Commands

define_node

End Node: DLUR is supported, but will not be used to connect to a DLUS in another subnet. If multi-subnet operation is not required, you should use this value instead of YES, to reduce network traffic and congestion at the network node.

This value is not supported for a Network Node.

NO

DLUR is not supported.

pu_conc_support

Specifies whether PU concentration is supported. Possible values are:

YES

PU concentration is supported.

NO

PU concentration is not supported.

nn_rar

The network node’s route additional resistance. This value is used in APPN route calculations to determine if the node is useful as an intermediate hop. A high value indicates that this node is not useful as an intermediate hop. Values must be in the range 0–255.

max_ls_exception_events

The maximum number of LS exception events to be recorded by the node.

max_compression_level

The maximum compression supported by the node for LU session data. This parameter must be set to LZ10 (the default); do not attempt to set any value other than the default.

ptf_flags

Options for configuring and controlling program temporary fix (ptf) operation. Set this parameter to NONE if none of the options described are required, or to one or more of the values described as follows. If two or more values are required, combine them with a + character.

Available options are:

NONE

None of the options described following are required.

OVERRIDE_ERP

SNAplus2 normally processes an ACTPU(ERP) as an ERP; this resets the PU-SSCP session but does not implicitly deactivate the subservient LU-SSCP and PLU-SLU sessions. SNA implementations may legally process ACTPU(ERP) as if it were ACTPU(cold), implicitly deactivating the subservient LU- SSCP and PLU-SLU sessions. To override the default processing and process all ACTPU requests as ACTPU(cold), use the value OVERRIDE_ERP.

SUPPRESS_BIS

SNAplus2 normally uses the BIS protocol prior to deactivating a limited resource LU 6.2 session. To suppress use of the BIS protocol so that limited resource LU 6.2 sessions are deactivated immediately using UNBIND(cleanup), use the value SUPPRESS_BIS.

OVERRIDE_REQDISCONT

SNAplus2 normally uses REQDISCONT to deactivate limited resource host links that are no longer required by session traffic.

144