Administration Commands
query_security_access_list
short_req_retry_limit decimal
path_switch_time_low decimal
path_switch_time_medium decimal
path_switch_time_high decimal
path_switch_time_network decimal
If the command executes successfully, SNAplus2 returns the following parameters:
path_switch_attempts
Number of path switch attempts to set on new RTP connections.
short_req_retry_limit
Number of times a Status Request is sent before SNAplus2 determines that an RTP connection is disconnected and starts Path Switch processing.
path_switch_time_low
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with transmission priority AP_LOW.
path_switch_time_medium
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with transmission priority AP_MEDIUM.
path_switch_time_high
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with transmission priority AP_HIGH.
path_switch_time_network
Length of time in seconds for which SNAplus2 attempts to path switch a disconnected RTP connection with transmission priority AP_NETWORK.
2.166.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
No parameter errors occur for this command.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.167 query_security_access_list
The query_security_access_list command returns information about security access lists defined in a SNAplus2 configuration file. It can return information about a single list or multiple lists, depending on the options used.
528
