Administration Commands
query_rtp_connection
Use a + character to combine this value with one of the following values:
FIRST_IN_LIST
Start at the first entry in the list.
LIST_INCLUSIVE
Start at the entry specified by the rtp_name parameter.
LIST_FROM_NEXT
Start at the entry immediately following the entry specified by the rtp_name parameter.
rtp_name
Name of the RTP connection. This value is ignored if the list_options parameter is set to FIRST_IN_LIST.
2.165.2 Returned Parameters: Summary Information
Parameter | Type | Length |
rtp_name | character | 8 |
first_hop_ls_name | character | 8 |
dest_node_name | character | 17 |
cos_name | character | 8 |
num_sess_active | decimal |
|
connection_type | constant |
|
If the command executes successfully and you specified SUMMARY as the list_options parameter value, SNAplus2 returns the following parameters:
rtp_name
Name of the RTP connection.
first_hop_ls_name
Name of the link station of the first hop of the RTP connection.
dest_node_name
Fully qualified name of the destination control point for the RTP portion of the session.
cos_name
Name of the class of service used by the RTP connection.
num_sess_active
Number of sessions active on this RTP connection.
connection_type
Specifies the type of sessions on the RTP connection. Possible values are:
CP_CP_SESSION
The RTP connection carries
LU_LU_SESSION
The RTP connection carries
ROUTE_SETUP
The RTP connection is used for route setup.
522