Administration Commands
delete_lu62_timeout
Name of the LU pool to be deleted or name of the LU pool from which LUs are to be removed. This name is an
lu_name
To remove one or more LUs from the pool without deleting the pool, specify the names of the LUs to be removed. Each name is a
To remove all LUs from the pool and delete the pool, do not specify any LU names.
2.82.2 Returned Parameters
No parameters are returned by SNAplus2 when this command executes successfully.
2.82.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
If the command does not execute because of a parameter error, SNAplus2 returns the following parameters:
primary_rc
PARAMETER_CHECK
secondary_rc
Possible values are:
INVALID_POOL_NAME
The supplied pool name was not valid.
INVALID_LU_NAME
One or more of the specified LU names did not match the name of an LU in the pool.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.83 delete_lu62_timeout
The delete_lu62_timeout command deletes a definition of an LU type 6.2 session timeout that was defined previously with a define_lu62_timeout command.
2.83.1 Supplied Parameters
Parameter name | Type | Length | Default |
[delete_lu62_timeout]
274
