Administration Commands
define_qllc_ls
INVALID_UPLINK
The branch_link_type parameter was set to UPLINK, but the definition of an existing LS between the local and adjacent nodes specifies that it is a downlink. The branch link type must be the same for all LSs between the same two nodes.
INVALID_DOWNLINK
The branch_link_type parameter was set to DOWNLINK, but the definition of an existing LS between the local and adjacent nodes specifies that it is an uplink. The branch link type must be the same for all LSs between the same two nodes.
State Check
If the command does not execute because of a state error, SNAplus2 returns the following parameters:
primary_rc
STATE_CHECK
secondary_rc
Possible values are:
DUPLICATE_CP_NAME
A link to the CP name specified in the adj_cp_name parameter has already been defined.
DUPLICATE_DEST_ADDR
A link to the destination address specified in the address parameter has already been defined.
INVALID_LINK_NAME
The link station value specified in the ls_name parameter was not valid.
INVALID_NUM_LS_SPECIFIED
The number of link stations specified was not valid.
LOCAL_CP_NAME
The name specified for the adj_cp_name parameter is identical to the local CP name.
LS_ACTIVE
The link station specified in the ls_name parameter is currently active.
PU_ALREADY_DEFINED
The PU specified in the pu_name parameter has already been defined.
DSPU_ALREADY_DEFINED
The downstream PU specified in the dspu_name parameter has already been defined.
DSPU_SERVICES_NOT_SUPPORTED
The dspu_services parameter was used to request a service that is not supported.
DEPENDENT_LU_NOT_SUPPORTED
The solicit_sscp_sessions parameter was set to YES, but dependent LU is not supported.
DUPLICATE_TG_NUMBER
The TG number specified in the tg_number parameter has already been defined.
TG_NUMBER_IN_USE
The TG number specified for the tg_number parameter is already being used by another LS.
166