Administration Commands
query_node
RSCVs are stored.
NO
RSCVs are not stored.
store_dlur_rscvs
Specifies whether RSCVs are stored for diagnostic purposes. If this parameter is set to YES, an RSCV is returned on the query_dlur_lu command; an RSCV is stored for each
YES
RSCVs are stored.
NO
RSCVs are not stored.
dlur_support
Specifies whether DLUR is supported. For a LEN node, this parameter is reserved. Possible values are:
YES
DLUR is supported.
LIMITED_MULTI_SUBNET
End Node: DLUR is supported, but will not be used to connect to a DLUS in another subnet.
This value is not supported for a Network Node.
NO
DLUR is not supported.
pu_conc_support
Specifies whether PU concentration is supported. Possible values are:
YES
PU concentration is supported.
NO
PU concentration is not supported.
nn_rar
The network node’s route additional resistance. Values must be in the range
hpr_support
Specifies the level of HPR (High Performance Routing) support provided by the node. Possible values are:
NONE
No support for HPR.
BASE
This node can perform automatic network routing (ANR) but cannot act as an RTP (Rapid Transport Protocol) end point for HPR sessions.
RTP
This node can perform automatic network routing (ANR) and can act as an RTP (Rapid Transport Protocol) end point for HPR sessions.
CONTROL_FLOWS
This node can perform all HPR functions including control flows.
485