Administration Commands
status_connectivity
2.198.3 Error Return Codes
If the command cannot be executed, SNAplus2 returns a primary return code to indicate the type of error and a secondary return code to provide specific details about the reason for unsuccessful execution.
Parameter Check
No parameter errors occur for this command.
State Check
No specific state errors, other than those listed in Appendix A, Common Return Codes from snapadmin Commands, occur for this command.
Other Conditions
Appendix A, Common Return Codes from snapadmin Commands, lists combinations of primary and secondary return codes that are common to all commands.
2.199 status_connectivity
The status_connectivity command returns information about the status of all the DLCs, ports, and link stations on the node.
2.199.1 Supplied Parameters
[status_connectivity]
No parameters are supplied for this command.
2.199.2 Returned Information
Each resource is displayed as being in one of the following states:
•Inactive
•Active
•Starting
•Stopping
•On demand (link stations only)
•Disabled (link stations only)
The following example illustrates the information returned for the status_connectivity command.
The amount of information returned depends on the width of your display; SNAplus2 attempts to determine this using the COLUMNS environment variable, and uses a default value of 80 if COLUMNS is not set. The Description text may be omitted or truncated if there is not enough room to display it.
Example
DLC Port LS PU Type Status Description
TOKEN0 | TR | Active | /dev/tr0 |
608
